Loading page
Preparing the detail.
The page is still on its way. You can return home whenever you need another route.
Return to the homepageThese records show the actual job, material and build choices. Photography is intentionally absent until it can document the specific delivered part.
| Part | Switchbox enclosure |
|---|---|
| Purpose | A PETG split body with a 3 mm lid, integrated M6 insert zones, wire pass-through, switch and gauge cut-outs, and local screw landings to reduce mass and warp risk. |
| Material | PETG |
| Nozzle | 0.4 mm |
| Layer | 0.2 mm |
| Envelope note | The body was divided into a base and lid, with the service face retained as a separate section. |
| Sector | Electrical equipment |
| Part | Manipulator component |
|---|---|
| Purpose | A component for a manipulator assembly, made to review its interface and moving geometry in the wider mechanism. |
| Material | PETG |
| Nozzle | 0.4 mm |
| Layer | 0.2 mm |
| Envelope note | The part fit within one build and was oriented around its assembly interfaces. |
| Sector | Robotics |
| Part | Segmented ducting manifold |
|---|---|
| Purpose | A manifold divided into sections, keyed and bonded to route air through a constrained installation. |
| Material | ABS |
| Nozzle | 0.6 mm |
| Layer | 0.28 mm |
| Envelope note | The branch geometry was divided at accessible joints so the assembled route could be checked before bonding. |
| Sector | Airflow systems |
| Part | Assembly jig |
|---|---|
| Purpose | A PA6-CF jig for locating a repeated assembly operation and keeping the operator sequence consistent. |
| Material | PA6-CF |
| Nozzle | 0.6 mm |
| Layer | 0.2 mm |
| Envelope note | The locating and support geometry remained within a single build. |
| Sector | Assembly tooling |
| Part | TPU gasket |
|---|---|
| Purpose | A flexible gasket made from the mating geometry for a defined assembly interface. |
| Material | TPU-95A |
| Nozzle | 0.4 mm |
| Layer | 0.2 mm |
| Envelope note | The perimeter fit within one build, avoiding a joint across the mating face. |
| Sector | Equipment service |
| Part | ASA outdoor housing |
|---|---|
| Purpose | A housing for equipment intended for exterior placement, with its mounting and access features reviewed as one assembly. |
| Material | ASA |
| Nozzle | 0.4 mm |
| Layer | 0.2 mm |
| Envelope note | The housing fit within one build and kept the mounting face continuous. |
| Sector | Outdoor equipment |